1.連接銅屏蔽:在裝好的接頭主體外部套上銅屏蔽編織網,用絕緣自粘帶把銅網套綁扎在接頭主體上,用恒力彈簧將銅網套固定在電纜銅屏蔽層上。將銅網套兩端修齊整,恒力彈簧前保留10mm,半重疊包繞兩層絕緣自粘帶,將恒力彈簧包覆住。2.恢復內護套:電纜三相接頭之間間隙，必須用填充料填充飽滿,再用PVC帶半重疊繞包,將電纜三相并攏扎緊,以增強接頭整體結構的嚴密性和機械強度。在兩端30 mm的內護套上用絕緣砂紙打磨粗糙并清洗干凈,然后從一端內護套上開始半重疊繞包防水帶至另一端內護套上一個來回，繞包時將膠帶拉伸至原來寬度的3/4,完成后,雙手用力擠壓膠帶,使其緊密貼附。