1)剝除線芯末端絕緣。用清沽紙清潔電纜絕緣表面，清潔時，從線芯端頭向外半導層方向擦拭，切不可來回擦。剝除線芯末端絕緣的長度為接線端子的孔深加5mm。剝除線芯絕緣時，不得損傷線芯導體，應順著導線絞合方向進行，不得使導體松散變形。

2)安裝終端。在三相分支手套口往下25mm處，繞包絕緣帶作標識，此處作為終端安裝基準。將硅脂涂在線芯表面(多涂)，套人冷縮式終端，用力將終端套入，慢慢拉動終端內的支撐條，直至終端下端口與標識對齊為止，不得超出標識。冷縮終端從根部向絕緣端部收縮，逆時針輕輕拉動支撐條，使冷縮管收縮(如開始收縮時發現終端和標識錯位，可用手把它糾正過來)。收縮要均勻，不能用力過大，以免造成附件損壞。在終端與冷縮護套管搭界處，必須繞包幾層絕緣自粘膠帶，加強密封。